| Last Modified: 11-29-2007 | 1.6 G | |
| Service Category: Vehicle Exterior | Section: Lighting (ext) | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000001DKJ00PX |
| Title: LIGHTING (EXT): HAZARD WARNING SWITCH: INSPECTION (2008 Sequoia) | ||
INSPECTION
1. INSPECT HAZARD WARNING SWITCH
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Switch Condition |
Specified Condition |
|---|---|---|
|
1 - 4 |
OFF |
10 kΩ or higher |
|
1 - 4 |
ON |
Below 1 Ω |
If the result is not as specified, replace the hazard warning signal switch.
(b) Check the illumination operation.
(1) Connect the positive (+) battery lead to terminal 3 and the negative (-) battery lead to terminal 2, and then check that the illumination illuminates.
OK:
Illumination illuminates.
If the illumination does not illuminate, replace the hazard warning signal switch.
|
|